Makita 6075D Manual de instrucciones

Cordless Driver Drill Capacities Steel Wood Wood screw Machine screw 10" 15mm 51mmx35mm 6 mm 1318'7 119132") 113164' x 1-3

Drilling operation 0 Drilling in wood . When drilling in wood, best results are obtained with wood drills equipped with a guide screw. The guide s

MAINTENANCE CAUTION : Always be sure that the tool is switched off and the battery cartridge is removed before attempting to perform inspection or ma

ACCESSOR I ES CAUTION: These accessories or attachments are recommended for use with your Makita tool specified in this manual. The use of any ot

Mar-O7-'89 EN CORDLESS DRIVER DRILL Model 6075D Note: The switch and other part configurations may differ from country to country. 13

MODEL 6075D Mar.-07-69 EN IFOM AtD DESCRIPTION 'Ft $tD DESCRIPTION MACHINE 1 2 3 4 5 6 7 8 10 9 12 13 18 19 11 14 15 16 17 20 21 22 23 24 6 2 1 2

P MAKITA LIMITED ONE YEAR WARRANTY Warranty Policy Every Makita tool is thoroughly inspected and tested before leaving the factory. It is warrante

IMPORTANT SAFETY INSTRUCTIONS (For All Tools) WARNING: WHEN USING ELECTRIC TOOLS, BASIC SAFETY PRECAUTIONS SHOULD ALWAYS BE FOLLOWED TO REDUCE THE RI

14. REMOVE ADJUSTING KEYS AND WRENCHES. Form habit of checking to see that keys and adjusting wrenches are removed from tool before turning it on. 1

IMPORTANT SAFETY INSTRUCTIONS I. SAVE THESE INSTRUCTIONS - Thismanual contains important safety and operating instructions for battery charger. 2. Bef

ADDITIONAL SAFETY RULES FOR CHARGER & BATTERY CARTRIDGE 1. Do not charge Battery Cartridge when temperature is BELOW 10°C (5OOF) 2. Do not attem

Installing or removing battery cartridge 0 Always switch off the tool before insertion or removal of the battery cartridge. 0 To remove the battery ca

Installing or removing driver bit or drill bit CAUTION : Always be sure that the tool is switched off and the battery cartridge is removed before ins

Speed change To change the tool speed, turn the speed change knob so that the arrow of the de- sired speed on the knob is aligned with the refer

Screwdriving operation Place the point of the driver bit in the screw head and apply pressure to the tool. Start the tool slowly and then increase