Makita LS1030N Especificaciones descargar pdf

SPECIFICATIONS

Model LS1030N

Blade diameter .....................................................................................................................255 mm — 260 mm

Hole (arbor) diameter

For all countries other than European countries ............................................................. 25.4 mm and 25 mm

For European countries ......................................................................................................................... 30 mm

Max. cutting capacities (H x W) with blade 260 mm in diameter

No load speed (min

–1

) ............................................................................................................................... 4,600

Dimensions (L x W x H) ........................................................................................530 mm x 476 mm x 532 mm

Net weight ...................................................................................................................................................11 kg

• Due to our continuing program of research and development, the specifications herein are subject to change

without notice.

• Note: Specifications may differ from country to country.

Power supply

The tool should be connected only to a power supply of the same voltage as indicated on the nameplate, and

can only be operated on single-phase AC supply. They are double-insulated in accordance with European

Standard and can, therefore, also be used from sockets without earth wire.

Miter angle

Bevel angle

0° 45° (left and right)

0°

90.5 mm x 95 mm

69 mm x 135 mm

90.5 mm x 67 mm

69 mm x 95 mm

Miter Saw

LS1030N

1 2 3 4 5 6 ... 11 12

Indice de contenidos

Pagina 1 - Miter Saw

SPECIFICATIONS Model LS1030NBlade diameter ...

Pagina 2

10If some part contacts the vise, re-position the visearm. Press the workpiece flat against the guidefence and the turn base. Position the workpiece a

Pagina 3

11MAINTENANCECAUTION: Always be sure that the tool is switched off andunplugged before carrying out any work on the tool. Alignment for squareness (Fi

Pagina 4

Makita CorporationAnjo, Aichi, JapanMade in China884146A8

Pagina 5 - 70 mm 70 mm 137 mm

2123 435687691181010121234567813514

Pagina 6

391011 1213 1415 16135 mm151617181921223232524262720

Pagina 7 - ENGLISH

42829322230313322534353637292937383940304342424117 1819 2021 2223 24

Pagina 8 - OPERATING INSTRUCTIONS

52947363048271249505144464546137 mm70 mm 70 mm 137 mm90 mm40 mm2526 2728 2930

Pagina 9

6SymbolsThe following show the symbols used for the tool. Be sure that you understand their meaning before use.❏ Read instruction manual.❏ DOUBLE INSU

Pagina 10 - Operation

7ENGLISH Explanation of general view 1Bolt 2 Center cover 3 Socket wrench 4 Shaft lock 5Loosen 6Arrow 7 Blade case 8 Saw blade 9Spindle 10 Flange 11 R

Pagina 11 - MAINTENANCE

820. Check damaged parts Before further use of the tool, a guard or other partthat is damaged should be carefully checked todetermine that it will ope

Pagina 12 - Makita Corporation

9CAUTION: • For all countries other than European countries(Fig. 6)The silver ring 25.4 mm in outer diameter is factory-installed onto the spindle. Th