Makita HM1100C Especificaciones

INSTRUCTION MANUALWARNING:For your personal safety, READ and UNDERSTAND before using.SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.www.makitatools.comD

10CAUTION:• Do not tighten the crank cap excessively. It is made ofresin and is subject to breakage.To maintain product SAFETY and RELIABILITY, repair

Memo11

Memo12

13First-ClassPostageRequiredPost Office willnot deliverwithout properpostage.Makita U.S.A., Inc.14930 Northam StreetLa Mirada, CA 90638-5753FoldCut

141. This product was purchased from:Home CenterHardware/Lumber StoreTool DistributorIndustrial SupplyConstruction SupplyOther ( )

15FACTORY SERVICE CENTERS1-800-4-MAKITARETAIN THIS PORTION FOR YOUR RECORDSALABAMA2365 Pelham ParkwayPelham, AL 35124 (205) 620-1791ARIZONA3707 E. Bro

WARNINGSome dust created by power sanding, sawing, grinding, drilling, and otherconstruction activities contains chemicals known to the State of Calif

2SPECIFICATIONS• Manufacturer reserves the right to change specifications without notice.• Specifications may differ from country to country.GENERAL S

36.Do not expose power tools to rain or wetconditions. Water entering a power tool willincrease the risk of electric shock.7.Do not abuse the cord. Ne

424.When servicing a tool, use only identicalreplacement parts. Follow instructions inthe Maintenance section of this manual.Use of unauthorized parts

5tion. Without proper warm-up, hammeringoperation is difficult.7.Always be sure you have a firm footing.Be sure no one is below when using thetool in

6FUNCTIONAL DESCRIPTIONCAUTION:• Always be sure that the tool is switched off andunplugged before adjusting or checking function on thetool.Switch act

7Side handle (auxiliary handle)The side handle can be swung 360° on the vertical andsecured at any desired position. It also secures at eight dif-fere

8Bit angleThe bit can be secured at 16 different angles. To change thebit angle, slide the change ring forward, then turn the changering to change the

9Remove the screws which secure the rear cover. Pry up therear cover with a screwdriver and remove it.Use a screwdriver to remove the brush holder cap