Makita HR4040C Manual de usuario

INSTRUCTION MANUALWARNING:For your personal safety, READ and UNDERSTAND before using.SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.www.makitatools.comR

10For chipping, scaling or demolishingWith the cut in the bit shank aligned with the notch in the toolholder cap, insert the bit into the tool holder.

11Depth gaugeThe depth gauge is convenient for drilling holes of uniformdepth. Insert the depth gauge into the hole in the grip base.Adjust the depth

12Chipping/Scaling/DemolitionSet the change lever to the symbol.Hold the tool firmly with both hands. Turn the tool on andapply slight pressure on t

13LubricationCAUTION:• This servicing should be performed by MakitaAuthorized or Factory Service Centers only.This tool requires no hourly or daily lu

14Connect the two terminals and reinstall the handle.CAUTION:• Do not tighten the crank cap excessively. It is made ofresin and is subject to breakage

15ACCESSORIESCAUTION:• These accessories or attachments are recommended foruse with your Makita tool specified in this manual. Theuse of any other acc

Memo16

17First-ClassPostageRequiredPost Office willnot deliverwithout properpostage.Makita U.S.A., Inc.14930 Northam StreetLa Mirada, CA 90638-5753FoldCut

181. This product was purchased from:Home CenterHardware/Lumber StoreTool DistributorIndustrial SupplyConstruction SupplyOther ( )

19FACTORY SERVICE CENTERS1-800-4-MAKITARETAIN THIS PORTION FOR YOUR RECORDSARIZONA3707 E. Broadway Rd., Ste. 6 Phoenix, AZ 85040 (602) 437-2850CALIFOR

2SPECIFICATIONS• Manufacturer reserves the right to change specifications without notice.• Specifications may differ from country to country.GENERAL S

WARNINGSome dust created by power sanding, sawing, grinding, drilling, and otherconstruction activities contains chemicals known to the State of Calif

3change the plug in any way. Double insula-tion eliminates the need for the three wiregrounded power cord and grounded powersupply system.5.Avoid bo

422.Use only accessories that are recom-mended by the manufacturer for yourmodel. Accessories that may be suitable forone tool, may become hazardous w

54.Be sure the bit is secured in place beforeoperation.5.Under normal operation, the tool isdesigned to produce vibration. Thescrews can come loose ea

6FUNCTIONAL DESCRIPTIONCAUTION:• Always be sure that the tool is switched off andunplugged before adjusting or checking function on thetool.Switch act

7Selecting the action modeRotation with hammeringFor drilling in concrete, masonry, etc., depress the lock but-ton and rotate the change lever so that

8Indicator lampThe green power-ON indicator lamp lights up when the tool isswitched ON. If the indicator lamp is lit but the tool does notstart, the c

9Bit grease (optional accessory)Coat the bit shank head beforehand with a small amount ofbit grease (about 0.5 -1 g; 0.02 - 0.04 oz.). This chuck lubr