Makita BFT080F Manual de usuario descargar pdf (Pagina 14)

Wiring diagram

P 14 / 15

Wiring in housing (12V model BFT123F)

Pass the endbell lead wires (black and

red) both sides of LED cover portion

of controller.

LED cover

portion

Endbell

lead wire

(black)

Endbell lead

wire (red)

Pass the following lead wires

between the ribs of switch.

* Controller's lead wires (white

and orange) to be connected

to micro switch.

* Controller's lead wires (blue,

purple and white) to be

connected to reverse switch.

* Controller's lead wires (red

and white) to be connected

to buzzer circuit.

Connector

Buzzer circuit has to be so mounted,

that the sponge side is faced to the

housing L side.

The connector has to be put

on the terminal side of this line

as illustrated.

Pass the following lead wires

between rib and the wall of

housing.

* Terminal lead wires

(black and red)

* Buzzer circuit lead wires

(white and red)

Buzzer

circuit

LED circuit

Controller

Switch unit

Switch

Rib

Rib

Pay attention, not to pinch the

above lead wires between switch

and housing.

Put the following lead

wires out of housing.

* Controller lead wires

(gray and blue) for

connecting to LED

circuit

* Controller lead wires

(purple and yellow) for

connecting to switch

unit

Refer to the wiring on the

switch unit in detail

on the next page.

Refer to the wiring on the

switch in detail on the next

page.

1

2

Terminal

1 2 ... 9 10 11 12 13 14 15

Comentarios a estos manuales

Sin comentarios