Makita BTS130 Especificaciones descargar pdf (Pagina 15)

-12-

Small flat-blade screwdriver

Pulse Unit [13]

Retaining Ring [1]

Retainer [2]

Retaining Ring [1]

Opening

Guide Sleeve (A) [4]

WARNING: Always remove the battery from the main body before starting repair or maintenance work.

Because the tool is cordless, leaving the battery inside and inadvertently activating the

switch will start unexpected motor rotation, possibly resulting in serious injury.

1. Precautions on Disassembly and Reassembly

The [Bold] numbers in the descriptions below correspond to item numbers in the Parts List and exploded

view assembly diagram of the Model WP 14DSL.

1. Guide Sleeve (A)

Follow the steps in Fig.1. You can take out Retaining Ring [1], Retainer [2], Guide Spring [3], and Guide

Sleeve (A) [4] in this order. Be careful not to lose the two Steel Balls D3.175 [12] in the main shaft hole of

the Pulse Unit [13].

Fig. 1-1

Secure the body of the Pulse Driver, match the

opening of Retaining Ring [1] to the notch of the main

shaft in Pulse Unit [13], and then insert the small flat-

blade screwdriver at an angle.

Fig. 1-2

Press down Retainer [2] with the small flat-blade

screwdriver.

Fig. 1-3

Slide the small flat-blade screwdriver under one

side of the gap of the Retaining Ring [1].

Fig. 1-4

Slowly raise the Retaining Ring [1] using the end

face of Guide Sleeve (A) [4] as a fulcrum.

One side of the opening of Retaining Ring [1] rises. Slowly lift the other portion of the opening with the

small flat-blade screwdriver. You can then remove it. Do not lift it up too quickly. Otherwise, Retaining Ring

[1] will pop out.

Disassembl

REPAIR GUIDE

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 30 31

Sin comentarios

Makita BTS130 Especificaciones Pagina 15