Makita HR2810T Manual de instrucciones descargar pdf (Pagina 7)

Attaching the quick change drill chuck

008234

Check the line of the quick change drill chuck shows the

symbol. Grasp the change cover of the quick change

drill chuck and set the line to the

symbol.

Place the quick change drill chuck on the spindle of the

tool.

Grasp the change cover of the quick change drill chuck

and turn the change cover line to the

symbol until a

click can clearly be heard.

Selecting the action mode

For Model HR2800

008236

This tool employs an action mode changing knob.

Select one of the two modes suitable for your work

needs by using this knob.

For rotation only, turn the knob so that the arrow on the

knob points toward the

symbol on the tool body.

For rotation with hammering, turn the knob so that the

arrow on the knob points toward the

symbol on the

tool body.

CAUTION:

• Always set the knob fully to your desired mode

symbol. If you operate the tool with the knob

positioned halfway between the mode symbols,

the tool may be damaged.

• Use the knob after the tool comes to a complete

stop.

For models HR2810, HR2810T, HR2811F, HR2811FT

Rotation with hammering

008206

For drilling in concrete, masonry, etc., rotate the action

mode changing knob to the

symbol. Use a tungsten-

carbide tipped bit.

Rotation only

008207

For drilling in wood, metal or plastic materials, lock

button and rotate the action mode changing knob to the

symbol. Use a twist drill bit or wood bit.

Hammering only

008208

For chipping, scaling or demolition operations, rotate the

action mode changing knob to the

symbol. Use a

bull point, cold chisel, scaling chisel, etc.

CAUTION:

• Do not rotate the action mode changing knob

when the tool is running under load. The tool will

be damaged.

• To avoid rapid wear on the mode change

mechanism, be sure that the action mode

changing knob is always positively located in one

of the three action mode positions.

Torque limiter

The torque limiter will actuate when a certain torque

level is reached. The motor will disengage from the

1. Action mode

changing knob

1. Action mode

changing knob

1. Action mode

changing knob

1. Action mode

changing knob

1. Spindle

2. Quick change

drill chuck

3. Change cover

line

4. Change cover

1 2 3 4 5 6 7 8 9 10 11 12

Comentarios a estos manuales

Sin comentarios

Makita HR2810T Manual de instrucciones Pagina 7

Comentarios a estos manuales

Relacionado con productos y manuales para Martillos perforadores Makita HR2810T